Plumbing · Bennett
Water heater repair, replacement and new installation across the metro. Tank, tankless, gas, electric and hybrid systems from the major brands. Same-day service on most repairs and replacements.
Ready to get started?Call (833) 653-0155 →
Full-service water heater repair and installation for homes and businesses across the metro, available 24 hours a day, 7 days a week.
Our background-checked technicians arrive on time, diagnose before they quote, and back every job with a warranty. No surprise charges and no shortcuts — just honest water heater service.
Local water has a moderate mineral content that wears on water heaters in predictable ways. Tank heaters typically last 8 to 12 years; after that the failure pattern starts: sediment, popping noises while heating, rusty hot water, a slow drip from the tank bottom, or a full leak. We diagnose it properly and tell you whether repair or replacement makes more sense.
Every job is quoted in writing before we start. No hourly meter and no overtime charges on emergencies. We pull permits where they are required and take the old tank away with us.
No hot water, lukewarm water, leaks or strange noises. We test the elements, thermostats, pilot, thermocouple and gas valve to find the failed part and fix it the same day in most cases.
When a tank is leaking from the bottom or past its service life, we replace it with a correctly sized gas or electric unit, bring the connections up to code and haul the old tank away.
A tankless heater gives endless hot water in less space. We size it to your peak demand and handle the gas line, electrical and venting it needs.
Heat pump water heaters move heat instead of making it, using far less electricity than a standard electric tank. We check the space and airflow they need before recommending one.
Five steps from the first call to hot water — the same on every installation.
We look at your household size, hot water use, fuel type, venting and the space the heater sits in, then size the unit so you do not run out of hot water or pay for capacity you never use.
You get a written, flat-rate quote with the options side by side — tank, tankless or hybrid — including what each costs to run, so the choice is yours and the price does not change on the day.
We shut off water and power or gas, drain the old tank, disconnect it safely and carry it out. Floors and walkways are protected the whole time.
The new heater goes in to code: new supply connections, shut-off valve, expansion tank where required, correct venting and a relief valve piped to a safe spot.
We fill and fire the unit, check for leaks and correct temperature, then show you how it works. We handle the permit and inspection where required and register the warranty in your name.
Water Heaters — Bennett
Our licensed technicians diagnose the real problem before quoting, so you do not pay to replace a tank that only needs an element or a thermostat.
We start with the safe homeowner checks, then run a real diagnostic. Electric units get heating element and thermostat tests; gas units get a pilot, thermocouple and gas valve check.
A unit under 8 to 10 years old with one clear failure is usually worth repairing. A unit over 10 years with several problems is usually a better candidate for replacement. You decide.
Most repairs are same-day with parts from the truck, and most replacements are same-day or next-day. We pull the permit where required, register the manufacturer warranty in your name and haul the old tank away.
Often needed alongside water heaters.
Tankless installation, tank-to-tankless conversion, descaling and repair.
Explore tankless water heaters in BennettNon-invasive detection of slab, wall, ceiling and underground leaks.
Explore leak detection in BennettKitchen, bathroom, laundry and main line drains cleared with cabling and hydro-jetting.
Explore drain cleaning in BennettSewer camera inspection, repair and trenchless replacement.
Explore sewer services in BennettA unit under 8 to 10 years old with one clear fault — a bad element, thermostat or pilot — is usually worth repairing. An older tank that leaks from the bottom, heats slowly and keeps needing parts is usually a better candidate for replacement. We check it and give you both prices.
On electric units it is often a failed heating element or thermostat; on gas units, the pilot, thermocouple or gas valve. Sediment built up in the tank also cuts how much hot water you get. A diagnosis tells you which one it is before anything is replaced.
Sediment settles on the bottom of the tank and water trapped under it boils as the burner heats. Flushing the tank often quiets it down; heavy build-up on an older tank is a sign it is near the end of its life.
Yes. A tankless conversion usually needs a larger gas line or a dedicated electrical circuit and new venting. We check what your home has and quote the full job, so there are no surprises on the day.
Most straightforward swaps take a few hours. Tankless conversions or jobs that need new venting or gas work take longer. We give you the timeline with the quote.
Yes. We pull the permit where your county requires one, arrange the inspection, register the manufacturer warranty in your name and haul the old tank away.
Rust-colored hot water usually means the inside of the tank is corroding. A rotten-egg smell is usually a reaction with the anode rod. Neither is an emergency on its own, but both are worth having checked before the tank fails.
No match. Call (833) 653-0155 and we will help.
