Whole-House Repipe
Every supply line in the home is replaced, planned to use the fewest wall openings, with water back on at the end of each day in most homes.
- Full supply replacement
- Fewest openings
- Walls patched
Plumbing · Bennett
Whole-House Repiping in Bennett
Whole-house and partial repiping across the metro — replacing old galvanized, polybutylene and failing copper pipe with PEX or copper. Planned carefully, finished cleanly, and done with your household in mind.
- Licensed
- Insured
- Free Estimates
- Family Owned
- 24/7 Emergency
Ready to get started?Call (833) 653-0155 →
Bennett Repiping: Better Water Pressure and No More Leaks
Whole-house and partial repiping for older homes, with the plan, materials and price agreed in writing first.
Repiping Planned Around Your Home and Your Schedule
Older homes with galvanized steel or polybutylene pipe tend to show the same signs: rusty water, falling pressure and leak after leak. Repairing one section at a time eventually costs more than replacing the system.
We plan the new layout to use the fewest wall openings, keep water on overnight in most cases, and protect floors and furnishings throughout the job.
When the new pipe is in and tested, openings are patched so the walls are ready for paint. The permit and inspection are handled for you.
Partial Repiping
When the problem is limited to one area — a bathroom group, a kitchen or a failing run — we replace only that section.
- Targeted replacement
- Condition check
- Lower cost
Galvanized Replacement
Galvanized steel corrodes from the inside, causing rusty water and falling pressure. Replacing it restores pressure and water quality.
- Rusty water fixed
- Pressure restored
- PEX or copper
Polybutylene Replacement
Gray polybutylene pipe, common in homes built from the late 1970s to the mid 1990s, can fail without warning. We replace it with modern pipe.
- Identify polybutylene
- Full replacement
- Insurance-friendly
Our House Repiping Process
Five steps from the first leak to a new plumbing system.
Step 1: Inspect the Pipe
We identify the pipe material and condition and find where problems are concentrated.
- Material identified
- Condition checked
- Pressure tested
Step 2: Plan the Route
We map the new layout to use the fewest wall and ceiling openings.
- Fewest openings
- Fixture by fixture
- Schedule agreed
Step 3: Written Quote
One written price covers materials, labor, patching and the permit.
- All-in price
- PEX or copper
- Permit included
Step 4: Repipe the Home
New lines are run fixture by fixture, with water restored at the end of each day in most homes.
- Home protected
- Water back nightly
- Done to code
Step 5: Test, Patch & Inspect
The system is pressure tested, openings are patched and the inspection is completed.
- Pressure tested
- Walls patched
- Inspection passed
House Repiping — Bennett
We Replace Pipe Systems Others Keep Patching
When the pipe itself is the problem, repiping ends the cycle of leaks and repairs.
- Galvanized Steel Pipe
- Polybutylene Pipe
- Copper Pipe Pinhole Leaks
- Rusty or Discolored Water
- Falling Water Pressure
How Our Repiping Works
- 01Inspect
We identify the pipe and where it is failing.
- 02Plan
A route with the fewest openings, priced in writing.
- 03Repipe
New lines, tested, patched and inspected.
Related Services
Often needed alongside house repiping.
Water Heaters
Repair, replacement and new installation of tank, gas, electric and hybrid water heaters.
Explore water heaters in BennettTankless Water Heaters
Tankless installation, tank-to-tankless conversion, descaling and repair.
Explore tankless water heaters in BennettLeak Detection
Non-invasive detection of slab, wall, ceiling and underground leaks.
Explore leak detection in BennettDrain Cleaning
Kitchen, bathroom, laundry and main line drains cleared with cabling and hydro-jetting.
Explore drain cleaning in BennettHouse Repiping across our service area
Serving 50 cities
- Arvada
- Aurora
- Bennett
- Berthoud
- Boulder
- Brighton
- Broomfield
- Castle Rock
- Colorado Springs
- Commerce City
- Conifer
- Dacono
- Denver
- Elizabeth
- Englewood
- Evans
- Evergreen
- Firestone
- Fort Collins
- Fort Lupton
- Fountain
- Fowler
- Frederick
- Gilcrest
- Golden
- Greeley
- Henderson
- Hudson
- Idaho Springs
- Johnstown
- Kittredge
- La Salle
- Littleton
- Lone Tree
- Longmont
- Louviers
- Loveland
- Mead
- Milliken
- Morrison
- Parker
- Platteville
- Pueblo
- Thornton
- Timnath
- Usaf Academy
- Westminster
- Wheat Ridge
- Windsor
- Woodland Park
House Repiping FAQs
Q: How do I know if my home needs repiping?
Frequent leaks, rusty or discolored water, low pressure throughout the house and old galvanized or polybutylene pipe are the usual signs.
Q: PEX or copper — which is better?
Both are reliable. PEX is flexible, resists freezing damage and needs fewer wall openings; copper is rigid and long-lasting. We recommend based on your home and budget.
Q: How long does a whole-house repipe take?
Most single-family homes take two to five days, depending on the size of the home and the number of fixtures.
Q: Will I have water during the repipe?
In most homes, yes — water is restored at the end of each work day.
Q: Do you repair the drywall afterwards?
Yes, openings are patched and left ready for paint.
Q: Is polybutylene pipe really a problem?
Polybutylene was widely used until the mid-1990s and is prone to failing without warning. Replacing it is usually recommended, and some insurers require it.
